USA Chamfer Rod - PDF Document

Presentation Transcript

  1. U.S. ALLOY CO. dba Washington Alloy 7010-G Reames Rd. Charlotte, NC 28216 www.weldingwire.com USA Chamfer Rod WASHINGTON ALLOY’S Quality Management System is Certified to ISO 9001 Cert # 05-R0925 ALLOY DESCRIPTION AND APPLICATION; USA Chamfer Rods are used for gouging, beveling and veeing out of excess metal in ferrous and nonferrous materials. This rod is most commonly used for removing old weld metal and sharp edges prior to subsequent welding operation. USA Chamfer Rods may be used with little or no oxygen/air present.Our Chamfer Rods may be used with AC or DC- (straight polarity) on any welding machine. Use the recommended amperage and hold the electrode at a low angle 10-15°, pushing it forward while applying slight pressure on the work piece. One pass will produce a clean groove, removing material equal to the diameter of the rod itself. Deeper grooves may be attainedby making multiple passes. These rods will produce a “blowing action” which removes all your unwanted materials (including dirt, grease, oil, rust etc.) from the base metal. It acts as a welding rod in reverse needing no gases or special equipment such as an air compressors or specialized electrode holder. Typical metals maybe Steels, low alloy steels, Stainless Cast Irons, Aluminum, and even copper base grades of base metals.DC - gives the fastest and cleanest of the two polarities. TYPICAL WELDING PROCEDURES; DCEN or AC Diameter 3/32” 1/8” 5/32” 3/16” OPTIMUM IN BOLD Amps 100-120-145 145-170-220 200-230-320 325-350-375 AVAILABLE SIZES: All sizes are packaged in 40 lb. cartons Or48 lbs in 6 plastic tubes Other sizes may be available – please inquire SPECIFICATIONS; N/A EAST COAST 7010-G Reames Rd Charlotte, NC 28216 Tel (888) 522-8296 Fax (704)598-6673 GULF COAST 4755 Alpine Drive #100A Stafford, TX 77477 Tel (877) 711-9274 Fax (281)313-6332 WEST COAST 8535 Utica Ave Rancho Cucamonga, CA 91730 Tel(800)830-9033 Fax (909)291-4586 Warehouse Distribution Center– Dayton, Ohio Head Office – Puyallup, Washington Washington Alloy Company believes that all information and data given is correct. Use this information to assist in making your own evaluations or decisions and thisinformation should not be mistaken as an expressed or implied warranty. U.S. ALLOY CO. assumes no liability for results or damages incurred from the use of any information contained herein, in whole or in part.